摘要核电站烟囱气载放射性流出物排放量关系到公众健康和环境保护,放射性排放监测结果是环境评价与源项调查的重要依据,所以在烟囱取样位置取得具有代表性的样品显得尤为重要。项目根据 ISO 2889-2010 新标准的要求,设计了某核电站反应堆烟囱模型,以验证预选取样位置是否满足取样代表性要求。本文重点介绍了试验方法、试验过程以及试验结果。试验结果显示,在预选取样截面 S1 处,正常风量工况的气体流速变异系数(COV)为 8.9%,最大风量工况下为 8.5%;两种工况下,各注入点注入示踪气体在取样位置所测浓度变异系数均小于20%,任何一点示踪气体浓度的测量值与平均值之差远小于 30%,气体流速分布均匀性和示踪气体分布均匀性符合标准要求,该取样位置“充分混合”,取得的样品具有代表性。本文所述试验是核电站烟囱取样代表性验证项目的重要内容,对国内其他类型的核电站和核设施烟囱放射性气态流出物取样代表性问题具有重要参考价值。 42438
毕业论文关键词 核电站烟囱;气载放射性流出物;取样代表性;气体流速;示踪气体;分布均匀性
Title Tracer Gas Uniformity Verification in Nuclear Power Plant Chimney Model
Abstract Because nuclear power station chimney of airborne radioactive effluent emissions related to public health and environmental protection, radioactive emission monitoring results is an important basis for environmental assessment and investigation of the source term. So to obtain a representative sample of chimney sampling location is very important. According to the requirements of the new standard of 2889-2010 ISO, a nuclear power plant reactor chimney model was designed to verify whether the pre-sampling position meets the requirements of sampling. This paper mainly introduces the test methods, process and results. The results show, in cross-section S1 at the preselected sampling, the normal condition of gas flow rate coefficient of variation (COV) of 8.9%, 8.5% maximum condition; two kinds of conditions, injection of the tracer gas injection point for each sample point the measured concentration coefficient of variation less than 20%, the difference between the average value measured at any point of the tracer gas concentration is far less than 30%, the flow rate of the gas distribution and trace gas distribution uniformity meet the standard requirements, the sample position "fully sample mixed "to obtain a representative. In this paper, the test is an important part of nuclear power plant chimney representative sampling verification project, to other types of domestic nuclear chimney of power plant and nuclear radioactive gaseous effluent sample representative has important reference value.
Keywords Nuclear power plant chimney; Airborne radioactive effluent; Representative sampling; gas flow rate; tracing gas; The uniformity of the distribution
目次
1绪论..1
1.1核电站烟囱气态流出物概述..1
1.1.1气态流出物的排放.1
1.1.2气态流出物的环境影响..2
1.2国内外现状2
1.3核电站烟囱的取样方法.3
1.3.1多点等速取样4
1.3.2单点取样..4
1.4试验目的及意义.6
2试验器材7
2.1烟囱比例模型..7
2.1.1烟囱模型结构7
2.1.2烟囱模型取样点位置8
2.2试验设备与材料..10
3试验方法.11
3.1风机标定试验11
3.1.1单风机标定试验11
3.1.2双风机组合标定试验.13
3.2气体流速分布均匀性试验.15
3.2.1试验目的15
3.2.2试验所需仪器.15
3.2.3试验步骤15
3.2.4试验结果17
3.3示踪气体均匀性试验19
- 上一篇:电池电镀化工厂周边土壤中放射性核素的种类与分布关系
- 下一篇:不同形貌Cu@Cu2O的合成及其对微量碘光催化吸附性能研究
-
-
-
大众媒体对公共政策制定的影响
乳业同业并购式全产业链...
当代大学生慈善意识研究+文献综述
电站锅炉暖风器设计任务书
中考体育项目与体育教学合理结合的研究
河岸冲刷和泥沙淤积的监测国内外研究现状
酸性水汽提装置总汽提塔设计+CAD图纸
十二层带中心支撑钢结构...
杂拟谷盗体内共生菌沃尔...
java+mysql车辆管理系统的设计+源代码